Hello Guys!

In this article, you will learn how to properly connect your LED Ring to the Arduino Controller. Please note that as of the 3rd version of the LED Ring, the Arduino board is protected. Please refer to this article in case of a need.

On the Arduino board (the black little box), if the port is at the bottom - the cables should be connected as follows:

Here are the LED ring cords colors and connection:

a. Attach a cable from GND on the Ring to GND on the Board [Black].                     

b. Attach a cable from 5v on the Ring to 5V on the Board [Red].  

c. Attach a cable from the DIN on the Ring to the D5 on the Board [White].