Troubleshooting Steps: When Two Bots Draw the Same Image DifferentlyUpdated 7 hours ago

Here’s a clear step-by-step troubleshooting sequence you can use to compare in case you have two bots that aren't drawing the same:

Step 1: Environment & Placement

1. Switch their table locations – see if the surface beneath is causing the issue.

2. Ensure both bots are sitting fully inside the paper holder.

Step 2: Holders

3. Switch the paper holders between the bots.

4. Remove and re-attach each pen holder to confirm it locks in securely.

5. Strengthen the pen holder if it feels loose.

6. Switch the pen holders between bots to isolate if one is faulty.

Step 3: Pen & Height

7. Verify the pen is inserted at the correct height (not too far down).

8. Use either new pens or the same pen in both bots for consistency.

Notes for Testing

• Always run Full Body Caricatures during comparison so you can properly judge drawing accuracy and keep customers satisfied.

• Use simple prompts or something you tested for consistency (not too long a prompt).